Table of Contents
Advertisement
B
Continued
i.
Add the new receivers to the Autoswitch
page of the web interface. Enter each
receiver's static IP address and assign it a
friendly name (e.g., "Salon") (see Figure 68).
IMPORTANT!
Also be sure to set each receiver's Dish Type
to 3-LNB and Switch Type to SWM, and
enable external device access, as directed by
the TV-Hub's Setup Wizard. If the TV-Hub is
then unable to communicate with the
receiver, try resetting the receiver (press its
red reset button or unplug it, wait 15 seconds,
then plug it back in and turn it on).
42
Using a DIRECTV Coax Network
Figure 68: Adding a DIRECTV Receiver to the Autoswitch Page
Hide quick links:
Advertisement
Table of Contents
