KVH Industries TracVision TV6 Installation Manual page 15

11 Continued
Linear Wiring
Follow these steps to connect linear receivers to
the TracVision system (linear universal quad LNB
required).
Connecting 1-4 Linear Receivers
a. Connect an RF cable from the "Receiver" jack
on the TV-Hub to the "Satellite In" jack on the
first receiver (see Figure 21). This receiver will
be able to control satellite selection in Automatic
satellite switching mode.
b. When connecting multiple receivers, connect
a grounding block in-line with each RF cable
from the antenna (see Figure 22 and
"Grounding Requirements" on page
c. Connect the other end of the RF1 cable to the
"Antenna" jack on the TV-Hub.
d. Connect any other RF cables from the
antenna (RF2, RF3, and RF4) to the "Satellite
In" jack on each additional receiver (see
Figure 22).
IMPORTANT!
To enable any of the additional receivers to
control satellite selection, install an optional IP
AutoSwitch (KVH part no. 72-0634) in-line
with the receiver's RF input. See Appendix A
on page 33 for details.
14
Wire the Receivers
Figure 21: Wiring 1 Linear Receiver
TV-Hub
23).
Figure 22: Wiring 2 to 4 Linear Receivers
TV-Hub
RF1
Receiver
Antenna
Satellite In
AC Power
RF1 RF2 RF3
Grounding
Blocks
Receiver
Antenna
Receiver
Satellite In
AC Power
Satellite In
Receiver
AC Power
Satellite In
Receiver
AC Power
Satellite In
Receiver
AC Power
Receiver
RF4