Table of Contents
Advertisement
18
Continued
Linear Receiver Setup for Automatic
Switching
For automatic switching to work properly using
the DiSEqC communications protocol, set up
linear receivers for the same satellites installed in
the TracVision system. Set up the satellites in the
receiver in the exact same order as they were set
up in the antenna. The specific setup process
varies among receiver models – refer to the
receiver's manual for details. Use the table below
and Figure 51 as a guide.
Satellites
Matching Satellites
in Antenna
in Receiver
Slot A
Port/Switch/LNB/DiSEqC 1 or A
Slot B
Port/Switch/LNB/DiSEqC 2 or B
Slot C
Port/Switch/LNB/DiSEqC 3 or C
Slot D
Port/Switch/LNB/DiSEqC 4 or D
Set Up the System
Figure 51: Linear Receiver DiSEqC Settings (Example)
31
Hide quick links:
Advertisement
Table of Contents
