Related Manuals for Sea Eagle 10.6 SR-RIK
Summary of Contents for Sea Eagle 10.6 SR-RIK
- Page 1 Transom Boats Instructions and Owner’s Manual 8.10YT - 10.6 SR-RIK - 12.6SR-RIK - 14SR-RIK October 2010...
- Page 2 About your new Transom Boat 10.6 SR-RIK (DROP STITCH FLOOR OPTION) Thank you for deciding to buy a new Sea Eagle Transom Boat. You Box 1: will get many years of use and pleasure out of this boat. 10.6 SR Boat Hull packed in Boat Bag with 12' Docking Rope,...
- Page 3 It will automatically stop once the pontoon is fully inflated at just like a jump cable. desired pressure of 3.2 PSI. Not for 8.10 YT and 10.6 SR-RIK drop stitch floors. Make sure your pump is off and hook the red positive alligator clip to the positive terminal of your battery.
- Page 4 Repeat with the other Uplift Connector Bar. Plastic Floor Assembly - Sport Slide the assembled boards into the bow of the Runabouts boat so that the keel valve can be reached through The Sport Runabouts feature Interlocking Polyethylene Floorboard the hole in the FB-2 System gives you an unmatched combination of high strength, floorboard.
- Page 5 Foot Pump. The High Pressure Drop Stitch Floor has to be inflated to side for a total of 4. These sturdy 7 psi. In the case of the SE 10.6 SR-RIK inflate the outside keel to 7 aluminum parts serve to strengthen psi after you have fully inflated the drop stitch floor.
-
Page 6: Motor Installation
If it is going to be in direct sunlight or exposed to leaves, berries or 2) Locate the hole in the material flange on rain, use a boat cover. Sea Eagle sells an excellent boat cover for our your boat. This will be between the front carry transom boats on our website at www.SeaEagle.com/accessories. -
Page 7: Troubleshooting
Patches: Leaks larger than a pinhole can be patched. Most patches can be done in a few minutes, but we do offer a repair service for The lifespan of your new Sea Eagle boat can be more complex jobs out of warranty. Our minimum repair fee is $75. -
Page 8: Deflation And Disassembly
Remove the floorboards by first removing the smaller of the side stringers. This will loosen the larger stringer, which should be The Sea Eagle Transom Boats are great tenders and can be rowed removed next. Remove and disassemble floorboards next. Then roll easily.