Advertisement
Connecting
A Liquid Propane Gas (LP gas)
Tank To Your Grill
1. Open the front Doors of cabinet. Pull out the
LPG Tank Pull-out Tray. Place a 20 Ib tank
with foot ring into the hole in the tray, See
Fig.15a.
Make sure the tank valve is in the
OFF positon,
2. Align the tank so the Tank Valve faces the
rear right corner
of cabinet.
Use the 5/
16"x89mm
Wing Bolt to secure gas tank from
rear of tray.See
Fig. 15a.
3. Check the tank valve to ensure it has proper
external
mating threads to fit the hose &
regulator assembly
provided
(Type 1 connec-
tion per ANSI Z21.58a-1998),
See Fig.15b
4. Make sure all Burner knobs are in the OFF
position.
5. Locate hose and regulator assembly packed for ship-
pingpurposeson front underside of grillhead. Remove
fastening band. Push assembly to back of grilland pull
down to connect to tank valve. Before connecting,
check valve and assembly threads to be sure they
match. (Type 1 connection per ANSI Z21.58a-1998).
See Fig 15b
6. Inspect the valve connection
port of the regulator
assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use damaged
or plugged equipment.
7. Connect the hoseand regulatorassemblytothetank
valve (See Fig 14b) Hand tighten Quick Coupling Nut
clockwise to a full stop. DO NOT use a wrench to
tighten because it could damage the Quick Coupling
Nut and result in a hazardous condition.
8. Open the tank valve fully (counterclockwise).
Use a
soapy water solution to check all connections
for
leaks before attempting to light your grill. See "Check-
ing for LP Gas Leaks" on page 17. If a leak is found,
turn the tank valve off and do not use your grill until the
leak is repaired.
Disconnecting
A Liquid Propane Gas (LP gas)
Tank From Your Grill
1. Turn the Burner Knobs and LP gas tank valve
to the full OFF position.
(Turn clockwise
to
close,)
2. Detach the hose and regulator
assembly from
the LP gas tank valve by turning
the Quick
Coupling Nut counterclockwise.
See Fig.15b
CAUTION: When the appliance
is not in use, the
gas must be turned off at the supply tank.
Figure
15a (LP gas model only)
FRONT
DOOR
TANK
TANK
PULL-OUT
TRAY
J
5/16"x89mm
WING
BOLT
Figure
15b (LP gas model only)
GRILL HEAD
FRONT
DOOR
\
\
Type
1
per ANSI Z21.58a-1998
TRAY
/
QUICK
COUPLING
NUT
ALREADY
CONNECTED
TO ADAPTOR
UNDER
SIDE BURNER
16
Advertisement
