Advertisement
Electrode Check - Requires an Assistant
Before placing the cooking components
into your
grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box ( a
3-1/4" wide stainless mechanism found at the front
between each set of Burners.) The easiest way to
ensure this is to perform this Electrode Check:
1.
Be sure all Control Knobs are set to "OFF"
and open the Grill Lid.
2.
Have an assistant
stand behindto
the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside Grill Head.
3.
Press the Ignitor Cap. You should hear a
"clicking"
sound and your assistant
should see
a small blue spark within each Gas Collector
Box. If a spark is present the Electrode
Tips
are properly positioned.
4.
If no spark is seen the Spark Gap shown in
Fig. 12 needs to be adjusted as follows:
Using an adjustable wrench,
loosen the Inside
Nut just until the Gas Collector
Box can be
maneuvered and turned upward.
The gap between the Spark Electrode Tip and
Spark receiver should be approximately 3/16".
if the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collector
Box until the gap is correct.
Return the Gas Collector Box to its original hori-
zontal position, secure the Inside Nut and try the
Electrode Check again.
5.
If no "clicking" sound is heard check the following
common causes, if you need assistance call our
Customer Service Helpline
at 1-888-317-7642,
•
ignitor AA battery not installed properly.
•
Ignitor wires may be loose. Remove the AA battery,
inspect the Ignitor Junction Box found behind the
Control Panel, and connect any loose wires.
Figure
12 - Side View Figure
Installing Cooking Components
Important: Before cooking on your grill the first
time, wash the Cooking Grids and Cooking Rack
with warm, soapy water. Rinse and dry thoroughly.
Season with cooking oil regularly. After cooking is
completed, turn grill to HIGH setting three to five
minutes to bum off rear grease or food residue.
1. Place the three Stainless Steel Flame Tamers
on the lower ledge above Burners. See Fig. 13
Evenly space the Stainless Steel Cooking Grids
2. (cross braces are bottom side) on the ledge
above the Flame Tamers.
,
Place the Stainless Steel Secondary
Cooking
Rack into the slots on the upper left and
upper right of Grill Bowl Side Panels. See
Fig.13
4. Remove Fastening Band from Pot Support and
place the Pot Support into the Side Burner
Body-Inner.
See Fig.13
Figure 13
SIS SECONDARY
COOKING
RACK
SIS COOKING
SIS FLAME
SLOTS
FOR
RACK
POT
SUPPORT
GAS COLLECTOR
BOX
SPARK
GAP
--_SPARK
RECEIVER
SIDE BURNER
14
Advertisement
