Advertisement
5. Place the Tank Pull-out Tray Kit on the Bottom
Shelf. Extend the Tank Tray outward from its
Bracket so you can align the holes on the Bracket
with the threaded holes on the top of Bottom Shelf.
Tighten securely by using 4 of the 114"x112" Phillips
Head Screws provided. See Fig. 4. Slide tray back
into Bracket.
6. Before installing the Door Bracket to the
inside of front Cart Side Panels be sure Door
Stops for Magnets on the Door Bracket
are
located
on the front side. See Fig. 5.
7.
Install the Door Bracket to the inside of front
Cart Side Panels• Align the threaded
holes on
the Door Bracket with the holes on Cart Side
Panels• Tighten securely by using 4 of the
l/4"x50mm
Phillips Head Screws provided.
See Fig. 5.
Figure 4 (LP gas model only)
CART SIDE
PANEL-LEFT
REAR
PANEL
TANK PULL-OUT
TRAY KIT
(LP gas model only)
t
I
!
i
TANK PULL-OUT
TRAY BRACKET
CART SIDE
PANEL*RIGHT
Installing
The Cabinet
Doors and Wire Basket
1, Remove the white protective film from the
stainless steel Door Panel and stainless steel
Door Axle Brackets•
2,
Install the Door Axle Bracket--left
bottom to
the Left Cart Side Panel. Insert Bracket upright
against Panel inside surface. Align Bracket and
Panel threaded holes• Thread two 3/16" x 9mm
Phillips Head Screws from the Panel front
through Bracket• See Fig. 6a. Tighten securely.
See Fig. 6b for correct assembly view.
3.
Place the axle on bottom of the Left Door
Panel in the Door Axle Bracket-left
bottom.
See Fig. 6b.
Figure 5
DOOR STOPS
FOR
MAGNETS
CART SIDE PANEL-LEFT
DOOR
BRACKET
CART SIDE
PANEL-RIGHT
Figure
6a
CART SIDE
PANEL- LEFT
I
Figure 6b
DOOR
AXLE
-LEFT
BOTTOM
\
\
CART SIDE
PANEL-LEFT
HOLE FOR
DOOR AXLE
BRACKET
BOTTOM
DOOR AXLE
-LEFT BOTTOM
SHELF
11
Advertisement
