Feature Setup Page - SOYO SY-P4VM800 Quick Start Manual

Boot To OS/2> 64MB
AGP Aperture Size
DRAM Timing
Hyper-Threading Function
Auto detect DIMM/PCI
Clock
Spread Spectrum
3.6 Features Setup Page
This page sets up some parameters for peripheral devices connected to the system.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Features Setup
OnBoard Floppy Controller
Serial Port1 Address
OnBoard IR Port
Parallel Port Address
Parrllel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
OnBoard PCI IDE Controller
OnBoard SATA-IDE
Audio Device
Modem Device
Ethernet Device
OnBoard USB Function
USB Function for DOS
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
↑↓←→
F1: General Help
OnBoard Floppy
Controller
Serial Port1 Address
OnBoard IR Port
SOYO SY-P4VM800 Quick Start Guide
Enable this item if you are booting the OS/2 operating
system and you have more than 64MB of system
memory installed.
This item defines an AGP for the graphics. Leave this
item at the default value 64MB.
This item allows you to enable or disable the DRAM
timing defined by the Serial Presence Detect electrical.
If your P4 CPU is not HT CPU, this item will be hidden.
If your P4 CPU is HT CPU, BIOS will show this item.
You can set "Disabled" or "Enabled" to control HT CPU
support in O.S. Set "Enabled" to test HT CPU function.
When this item is enabled, BIOS will disable the clock
signal of free DIMM/PCI slots.
Use this item to set the system bus spread spectrum for
the installed processor.
Enabled
3F8/IRQ4
Disabled
378
ECP
DMA3
IRQ7
Both
Enabled
Enabled
Auto
Enabled
Enabled
Disabled
F9: Optimized Defaults
Use this item to enable or disable the onboard floppy disk
drive interface.
Use this item to enable or disable the onboard COM1/2
serial port, and to assign a port address.
Use this item to enable or disable the onboard infrared port,
21
Help Item
Allows BIOS to Enable or Disable
Floppy Controller.