Table of Contents
Advertisement
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
N.B. To install the stove, use only authorised and
trained personnel, or contact the dealer.
1. Check that the floor can support the total weight
of the stove (140kgs).
2. Refer to the figure that shows the dimensions
of the flue pipe, and allowing for the thickness
of the floor-protection base (if applicable), make
a hole in the chimney to accommodate the
smoke outlet pipe (diameter 80 mm).
3. Connect the stove to the chimney with a certi-
fied steel pipe suitable for this use and seal it.
This appliance must not be connected to a
shared flue.
4. Leave adequate clearance around the stove for
cleaning and servicing. If the appliance is to be
installed in an alcove a minimum of 400mm
clearnace is required all round to allow access
for cleaning and servicing.
HEARTH DIMENSIONS
The hearth should extend 15cm to the rear of the
stove and 14cm to both sides and 30cm to the front.
Min 150mm
Min 140mm
Fig.1
Fig.2
Min 300mm
Min 140mm
STOVE DIMENSIONS (MM)
Fig.3
Fig.4
1032
Fig.5
Air Intake
3
566
637
Flue Outlet
177.8
Advertisement
Table of Contents
