Table of Contents
Advertisement
MANAGING ALARMS
An alarm indication may appear in one of the follow-
ing cases (the alarm can be cleared by pressing
button 4 "ON OFF":
-
Flue gas temperature probe alarm
If there is a fault in the flue gas temperature probe,
the message "ALARM SOND FUMI" appears and
the ventilator and extractor fan are switched on at
maximum speed.
-
Flue gas over-temperature alarm
If the flue gas temperature rises above 280° C, the
message "ALARM HOT TEMP" appears and venti-
lator and extractor fan remain lit until the decrease
of flue temperature.
-
Ignition failure alarm
-
Extractor alarm (if this option is available)
This appears if the initial attempt to ignite has failed,
or if stove temperature is too low for operation,
even after the full ignition period has elapsed. The
message "ALARM NO FIRE" is displayed and the
extractor fan remains lit for a pre-set time until the
stove is completely switched off.
-
Pressostat alarm
Incase the exchanger gets dirty or the chimney is
obstructed, the safety pressostat switches the
motor auger off (stops the fuel).
In special weather conditions, the pressostat
switch can operate even if there is no bad func-
tioning of the stove. This can be caused by the
lower draught of the chimney. Please consider
this event as a normal one, it does not depent
on the stove.
-
Safety thermostat alarm
In case of irregular stove temperature, the safety
thermostat operates and shows on the display the
following notice: "ALARM TERM SICC". To restart
the stove, wait until cool and unblock it as shown in
Fig.
Fig.11
ALARM
SOND FUMI
1. Unscrew the cap
anticlockwise
ALARM
HOT TEMP
ATTENTION: the thermostat has to be reset by
cooled stove.
The control panel is situated in the lower rear
part of the stove.
ALARM
NO FIRE
N.B. the thermostat does not unblock until the
stove has cooled completely.
If the thermostat reset has been successful, a click
cna be heard when you press the button. Before
every new ignition, verifty that the burn pot is com-
pletely empty; if not, clean it immediately.
The alarm signals can be cancelled by switch-
ing off and on the stove with button No.4 situat-
ALARM
ed in the frontal panel of the stove.
DEP FAIL
Ensure Air Inlet and flue gas outlet are clear
from obstructions.
If the flue gas temperature rises above 260°C, the
stove goes into Economy mode and the message
ECO
The message
ted room temperature has been reached.
SWITCHING OFF
ALARM
The stove can be switched off in different ways:
SIC FAIL
1. Manually (putting the On/Off switch on the back
of the stove in the Off position).
2. By actuation of a room thermostat, if this is con-
nected.
3. By a timer program.
4. Using the remote control (if this option is avail-
able).
11
2. Push The Button
appears on the display.
also appears when the selec-
ECO
Advertisement
Table of Contents
