Changing The Printer Port - Star Micronics LC-240C User Manual

If you see that your printer requires adjustment, select the box for the mode
you want to adjust (by clicking inside it with the mouse or by moving to it
by pressing Tab).
Next, select a negative value to shift the lower row left, or a positive value
to shift the lines right. The extent of the shift is indicated by the size of the
value.
Use the same procedures as you do for other parameters to scroll through the
list of settings and select the one you want (see "Changing User Setup Utility
parameter settings" on page 18).
After you make an adjustment, you can check its affect on printing by
printing a test again.
Repeat the above steps for each mode, if necessary

Changing the printer port

The following operation is used to supply printer port information to the
computer.
While in the User Setup Utility, select Port from the menu bar.
Select the port name you want to use from the list on the display.
If you are using a parallel cable, you will probably be using LPT1. If you are
using the optional Setial-To-Parallel Interface Converter, you should
normally be using COM1 or COM2.
Load Save General
Exit
Selected
Port
TAB = Next Box = Scroll up
SPACE = Set Function = Scroll down
Changing the printer port
Font Paper Adjust. Port
(•) LPT1
*
( ) LPT2
= Menu Select
Help
27