Special Commands; Pause Duration; Begin New Rule - Symbol LS 9208 Reference Manual

Hide thumbs Also See for LS 9208:

Table of Contents

Advanced Data Formatting

Special Commands

This parameter allows a pause to be inserted in the data transmission. Pauses are set by

scanning a two-digit number (i.e., two bar codes), and are measured in 0.1 second

intervals. For example, scanning bar codes "0" and "1" inserts a 0.1 second pause; "5" and

"0" gives you a 5 second delay. Numeric bar codes begin on page

Codes. If you make an error or wish to change your selection, scan Cancel bar code on

page 12-9. The default for Pause Duration is 1 second.

Pause Duration

Scan this bar code to start entering a new rule.

Begin New Rule