Page 1
LS9203 Setup Instructions for Autogas REGAL Touch...
Page 2
LS9203 Setup Instructions Introduction This document provides instructions for programming the Symbol LS9203 scanner for use with an Autogas REGAL Touch. Required Hardware • Cable • CBA-R01-S07PA (RS232 Cable, DB9 Female, TxD on 2, 7 ft. Straight), or • CBA-R02-C09PA (RS232 Cable, DB9 Female, TxD on 2, 9 ft. Coiled).
Page 3
Scan the following bar codes to configure the LS9203 scanner: Set All Defaults Standard RS-232 Parity Space...
Page 8
LS9203 Setup Instructions 73-60833-SI05 73-78423-SI03 Revision A - September 2004 Revision A - December 2005 Symbol Technologies, Inc. Symbol Technologies, Inc. One Symbol Plaza One Symbol Plaza Holtsville, N.Y. 11742-1300 Holtsville, N.Y. 11742-1300 http://www.symbol.com http://www.symbol.com...