Timing Chain; Drive Chain - Bike Friday Family Tandem Traveler User Manual

Assembly: Timing Chain
15. Mount Brake Housing
If the cable housing is not in
the cable stop, insert it now.
Pull the small spring over
the brake cable back from
the housing ferrule, and slip
the brake cable into the cable
stop (there is a slot in the
cable stop for this). Release
the spring.
16. Connect Cable Splitter
Next connect the two ends
of the brake cable split-
ter. Screw the two halves
together securely. Leave the
rim brake open for now.
17. Install Timing Chain
Remove the timing chain
from the felt pouch. The tim-
ing chain has two separate
silver connector links. These
silver links are to help you
"time" the captain's and
stoker's crank arms.
14
www.bikefriday.com
Fig. 15 Drum brake cable housing stop.
Fig. 16 Drum brake cable splitter.
Fig. 17 Timing chain silver link.
800-777-0258 • +1-541-687-0487
Assembly: Drive Chain
18. Match Timing Marks
Drape the chain over the rear
timing chain ring (you may
need to slip the drive chain
off the drive chain ring,
depending on your model).
Line up a silver link with
the small stamped mark on
the chain ring. (Some chain
rings have a small hole
drilled instead.) Repeat with
the front timing chain ring.
19. Mount Timing Chain
With the timing marks
aligned, turn the crank arms
until the timing chain is
seated on both chain rings.
20. Attach Drive Chain
With the timing chain
installed, pull the drive chain
over the drive chain ring.
800-777-0258 • +1-541-687-0487
Fig. 18 Front (left) and rear (right).
Fig. 19 Timing chain on.
Fig. 20 Mounting timing chain.
www.bikefriday.com
15