Network Deployment; Waterproof Connection - Vivotek IP8362 Quick Installation Manual

4

Network Deployment

Power over Ethernet (PoE)
Using a PoE-enabled switch
The Network Camera is PoE-compliant, allowing transmission of power and data via a single
Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled
switch via Ethernet cable.

Waterproof Connection

Connect the camera's RJ45 connector through a waterproof cable gland, and to another Ethernet
cable at the installation site. Wrap the rubber seal around Ethernet cables and squeeze it into the
claws to prevent moisture. Make sure the components are tightly fastened.
From Camera
Waterproof Connector
PoE Switch
RJ45 Female/Famale
Feed-through
RJ45
EN-5
Rubber Seal
Seal Nut
To LAN/WAN
Body w/ Claws