Hardware Installation - Vivotek IP8362 Quick Installation Manual

3

Hardware Installation

1. Attach the alignment sticker to the wall. Drill three holes into the wall. Then hammer the supplied
plastic anchors into the holes and secure the plate with supplied screws.
2. Feed the cables through the front opening of the wall mount bracket.
3. Hang the wall mount bracket on the plate.
4. Fix the Network Camera on the wall mount bracket with two screws on both sides.
5. Secure the wall mount bracket with the supplied screws.
6. Adjust the angle of the wall mount bracket to aim at the shooting area.
1
5
3
4
The supplied L-type hex key wrenches
4
are exclusively designed to match each
5
screw. In case you will need to adjust the
6 lens later, do not discard the wrenches.
EN-4
2
6