Kenmore 630.1395 Use And Care Manual page 20

Dishwasher did
nat sanitize
Dishwasher nat
draining
Etching
(permanent
cloudiness)
_'Sudsing"
1o Did not run a sanitizing cycle
2o Opened door mid-cycle
1. Kinked or Crushed Drain Hose
2o No high Laop in Drain Hose
3o Food Disposer plug not removed
4o The airgap may need cleaning
5o A home plumbing issue°
1o Type of glass - some glassware is sensitive to
temperature
2o Too much detergent
3o Too much detergent and jar wrong type of
detergent and jar wrong brand of detergent°
1o Select a cycle that is intended to sanitize° See
Dishwasher cycles and options section for more
information°
2o Do nat open the door while the wash cycle is running°
1o Check Drain Hose for proper installation° Note: In the
Installation Process, do not rotate the Drain Hose after
it is attached to the dishwasher° Refer to Installation
Instructions for details°
2o Make sure that a portion of the Drain Hose is at least
20" from the floor° Refer to Installation Instructions for
details°
3o If your Drain Hose is attached to the Food Disposer
make sure the plug in the Food Disposer was removed°
4o Clean the air gap periodically to ensure proper
drainage of the dishwasher° With most types, you lift
off the chrome cover° Unscrew the plastic cap° then
check for any soil buildup° Clean if necessary°
5o In this case, a certified plumber would need to check°
1o Make sure that glasses are Dishwasher safe° Select a
cycle that does nat get as hat° Do nat use the Heated
Dry option°
2o The amount of detergent is based on the hardness of
the water deliveried to your dishwasher and the amount
of food soil present° If you pre-rinse your dishes and!
or have soft water you should reduce the amount of
detergent° See Owners manual for details°
3o Reduce or change the type!brand of detergent you are
using° Note_ Do not pre-rinse dishes° Scraping excess
food soils is all that is required°
2O