Rev. 01/2008
Jam 12
Initial Jam
Message: Paper Misfeed: Inverter Guide Plate
The trailing edge sensor switches ON when the printer is switched on or
Jam
while printer is initializing.
Cause:
Problem Site
Perform check, take action in this order:
1.
2.
Action
3.
4.
5.
6.
⇒
Jam 14
Carriage Jam
Message: Ppr Misfd: Scan.Unit
The carriage was prevented from reaching its target position within the
Jam
prescribed time.
Cause:
Problem Site
Action Perform check, take action in this order:
SM
CÓPIA NÃO CONTROLADA
The trailing edge sensor does not change (go OFF).
Paper feed clutch remains ON.
Trailing edge sensor
Paper feed clutch
Clean the transfer belt.
Replace inverter guide plate.
Replace trailing edge sensor.
Replace 1st Registration sensor.
Replace 2nd Registration sensor.
Replace CTL board.
A piece of paper or other object is obstructing the movement of the
carriage.
A piece of paper or other object is obstructing the paper path.
The horizontal film encoder is dirty, slack, buckled, or damaged.
Horizontal feed motor belt is loose or broken.
Horizontal encoder film strip
Horizontal feed motor belt
CTL board
4-35
CÓPIA NÃO CONTROLADA
SC Error Codes
J012/J013/J014