Unit Configuration, Remote Configuration, Guide For Owner And Accessories - Carrier 42PQV Installation Manual

42PQV/38VBH
Unit configuration, remote configuration, guide for the owner and accessories
Table VI: Unit configuration
ITEM Shown on display
1 "rAdr"
2 "UCFG"
3 "UAdr"
4 "ZONE"
5 "GFdn"
6 "A St"
Note:
The selections of item 2, 3, 4 and 5 are not changeable in the unit even though remote control selections for these items are possible.
Table VII: Remote configuration
Shown on display
"CH"
"tU"
"rc"
"HR"
"CR"
"CL"
Note:
If the selection is changed from "rc" (HP operation) to cooling only
and the remote control operating mode is auto or heating, the
operating mode is set to cool.
Guide for the owner
When installation and tests are completed explain the Operation
and Maintenance Manual to the owner, with particular attention to
the main operating modes of the air conditioner, such as:
• Turning the unit on and off.
• Functions of the remote control.
• Removal and cleaning of the air filters.
Leave the installation manual with the owner for future use during
maintenance operations or for any other needs.
GB - 20
Explanation
"A" remote unit A
"b" remote unit B
"Ab" remote unit A and b
"HP" heat pump
"AC" cooling only
1- 40 with increase of 1
2
1- 40 with increase of 1
2
1- 40 with increase of 1
2
"OF":unit in stop mode
Explanation
"A":unit A
"b":unit B
"Ab":unit A and B
"C":Degrees Celsius
"F":Degrees Fahrenheit
"HP":heat pump
"AC":cooling only
17-32:17°C~32°C
63-90:63°F~90°F
17-32:17°C~32°C
63-90:63°F~90°F
12:12hour clock (AM/PM)
24:24hour clock
Description
Remote address indoor unit A.
Remote address indoor unit B.
Default address both indoor unit.
Default address is heat pump.
Change address for cooling only.
CCN unit address.
Number of zone.
Number of GFD.
Choose of operating mode after a power supply
interruption.
description
Address indoor unit A.
Address indoor unit B.
Default address is both indoor units.
Temperature.
Default is °C.
Default address is heat pump.
Change address for cooling only.
Maximum heating setpoint in °C.
Maximum heating setpoint in °F.
Minimum cooling setpoint °C.
Minimum cooling setpoint °F.
Time format (AM=morning; PM=afternoon).
Default is 12.
Note:
If the "HR" is set to a value that is lower than "CR" and the remote
control operating mode is auto, the operating mode is set to
cooling.
Table VIII : Accessories
Description
Wall bracket kit
Active carbon filter and
Passive electrostatic filter
Deafault=1
Deafault=0
Deafault=1
42PQV/38VBH
009 012
•
•
•
•