IR Remote Control “Room Controller” “Zone Manager” The unit can be used with infrared Remote Control, with the Carrier “Room Controller” or “Zone Manager” remote control. Infrared control instructions are contained in the present manual. Remote controls instructions are contained in the relevant manuals.
42PQV...X General information Unit operation and maintenance • This unit will only work safely and correctly, if installed and tested by qualified personnel. Read this instruction manual thoroughly before using the • Do not open the remote control to avoid possible damage.
42PQV...X System description E N G L I S H 050S 080S 110S EMER. Blue indicator light Orange indicator light Green indicator light Switch panel Indoor unit display Emergency operation: • Blue light: illuminated during Ionizer activated When the unit is in the OFF mode and the T button is pressed for •...
42PQV...X Air cleaning system, optimum comfort and lowest consumption, correct cleaning Air cleaning system Ensure that the air distribution in the room is uniform by properly adjusting the air flow direction. Cleaning the Ioniser Standard air filters : they eliminate dust and lint.
42PQV...X Cleaning, maintenance, before a long shutdown period E N G L I S H Filter cleaning Air conditioner maintenance Clean filters in accordance with the actual operating conditions and times. Cleaning unit coil: It is recommended to clean the coil at least at the beginning of each cooling season or when necessary;...
42PQV...X Infrared remote control E N G L I S H • Remove the used batteries and insert new batteries. The remote control uses two alkaline batteries (1.5 V, LR03x2). • Press the reset button “O” with a sharp object to reset the remote control.
42PQV...X Use of the remote control Current time adjusting and reset buttons Selection of the operating mode (buttons K and O) (button A) Press current time adjusting button for more than 5 seconds to With this button the operating mode of the air conditioner can be adjust the current time.
Page 10
42PQV...X Use of the remote control E N G L I S H Selecting the fan speed Louvre positioning (button E) Now this icon is flashing. Use button , to select desired position. Press button for confirmation. The fan speed can be selected by pressing button Now all icons are fixed on display.
42PQV...X Use of the remote control Sleep timer procedure “night” (button M) DAILY timer (Everyday - button J) Press this button to set the SLEEP timer with remote control on. Push the button when the ON or OFF timer is active. The icon The icon will appear on the display.
42PQV...X Troubleshooting E N G L I S H After inserting the batteries in the remote control, the display The remote control display does not change when any button does not illuminate: is pressed: • The batteries are exhausted or the polarity is incorrect; replace •...
Page 13
42DH8C54020 - R Via R. Sanzio, 9 - 20058 Villasanta (MI) Italy - Tel. 039/3636.1 The manufacturer reserves the right to change any product specifications without notice. April 2006. Printed in Korea...
Need help?
Do you have a question about the 42PQV...X and is the answer not in the manual?
Questions and answers