Assigning Address To Indoor Unit - Samsung AVMKH020CA0 Installation Manual

Assigning Address to Indoor Unit

1 Before installing the indoor unit, assign an address to the indoor unit
according to the air conditioning system plan.
2 The address of the indoor unit is assigned by adjusting MAIN(SW02) and
RMC(SW01) rotary switches.
K1 K2 K3 K4
K5 K6 K7 K8
SW03 SW04
3 The MAIN address is for communication between the indoor unit and the outdoor
unit. Therefore, you must set it to operate the air conditioner properly.
It is required to set the RMC address if you install the wired remote controller
4
and/or the centralized controller.
5 If you install optional accessories such as the wired remote controller, centralized
controller, etc. see an appropriate installation manual.
6 If an optional accessory is not installed, you do not have to set the RMC
address. However, adjust K1 and K2 switches of the SW03 DIP switch to
"ON" position in this case.
7 Set the MAIN address by adjusting the rotary switch(SW02) from 0 to F. Each
indoor unit connected to the same outdoor unit must have different address.
i. e. If an indoor unit does not have an optional accessory and its MAIN address
is "4"
K1 K2 K3 K4
K5 K6 K7 K8
SW03 SW04
K9 K10 K11 K12
SW05 SW01 RMC SW02 MAIN
K9 K10 K11 K12
SW05 SW01 RMC SW02 MAIN
15
E-