Installing The Upper Handle; Loose Parts - Toro Power Max 6000 Operator's Manual

1. Disengage
2. Wheel drive
3. Engage
Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.

1. Installing the Upper Handle

4 Handle bolts
4 Curved washers
4 Locknuts
Procedure
Note: Do not remove the rubber band until you have
installed the upper handle.
4. Read the Operator's
Manual.
5. Do not place your hand
in the chute; stop the
engine before leaving the
operator's position, use the
tool to clear the chute.
6. Thrown objects, keep
bystanders a safe distance
from the snowthrower.
Description
Handle bolts
Curved washers
Locknuts
No parts required
Carriage bolts
Locknuts
No parts required
No parts required
No parts required
112-6623
7. Keep away from moving
parts, remove the
ignition key and read
the instructions before
servicing or performing
maintenance.
8. Disengage
9. Auger drive
Qty.
4
4
4
–
2
2
–
–
–
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables are not pinched between
the handle sections.
7
10. Engage
Use
Install the upper handle.
Install the traction control linkage.
Install the chute control rod.
Check the tire pressure.
Check the skids and scraper.
Check the operation of the traction drive.