Mercury 200 Optimax DTS Owner's Manual page 49

6. For initial start of a new engine or for an engine that ran out of fuel, or was drained of fuel, the fuel system
should be filled as follows:
a. Squeeze the fuel line primer bulb until it feels firm.
b. Turn the ignition key switch to the "ON" position for three seconds. This operates the electric fuel pump.
c. Turn the ignition key switch back to the "OFF" position, and squeeze the primer bulb again until it feels
firm. Turn the ignition key switch to the "ON" position again for three seconds. Continue this procedure
until the fuel line primer bulb stays firm.
7. Turn the ignition key to "START" position and release the key. The electronic starting system will
automatically crank the engine for starting. If the engine fails to start, the engine will stop cranking. Return
the key to "START" position and try again. Repeat the procedure for the second engine.
8. The "ACTIVE" light located on the console remote control key pad will become illuminated once the engine
is started and communicating with the remote control.
9. Check for a steady stream of water flowing out of the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump indicator hole, stop engine and check cooling water
intake holes for obstruction. No obstruction may indicate a water pump failure or blockage in the cooling system.
This condition will cause the engine to overheat. Have the outboard checked by your dealer. Operating the engine
while overheated will cause engine damage.
OPERATION
N
F
3485
ACTIVE
STATION SELECT
43
R
3417
ob00354
SYNC
THROTTLE
ONLY
3424