Mercury 200 Optimax DTS Owner's Manual page 43

1. Lower the outboard to the vertical operating position. Make sure all cooling water intake holes are
submerged.
2. Open fuel tank vent screw (in filler cap) on manual venting type fuel tanks.
3. Squeeze the fuel line primer bulb several times until it feels firm.
NOTE: The engine will not start unless the lanyard is set to the "RUN" position.
4. Set the lanyard stop switch to "RUN" position. Refer to General Information ‑ Lanyard Stop Switch.
5. Shift outboard to neutral (N) position.
OPERATION
ob00350
N
F
37
ob00668
ob00348
ob00349
R
3413