Technoline WIRELESS 433 MHz WEATHER CLOCK Instruction Manual page 5

Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting up procedures. This is because a random security code is assigned
by the transmitter at start-up and this code must be received and stored by the Weather
clock in the first 3 minutes of power being supplied to it
SETTING UP:
1. First, insert the batteries into the Weather clock (see "How to install and replace
batteries in the Weather clock"). Once the batteries are in place, all segments of
the LCD will light up briefly and a short signal tone will sound. Following some test
data display, the indoor temperature and humidity, the time as 0:00 the date as 1.1.
05 and the "weather man" icon will be displayed. If the indoor temperature and
humidity are not displayed after 30 seconds, remove the batteries and wait for at
least 10 seconds before reinserting them. Once the indoor data is displayed
proceed to step 2.
2. Immediately after and within 3 minutes of activating the Weather clock, place the
batteries into the transmitter (see "How to install and replace batteries in the
Temperature transmitter").
3. After inserting the batteries into the transmitter, the Weather clock will start
receiving data from the transmitter. The outdoor temperature should then be
displayed on the Weather clock. If this does not happen after 15 minutes, the
batteries will need to be removed from both units and reset from step 1.
4. The Weather clock can take up to 3 remote transmitters. If you have purchased
additional transmitters, follow step 2 for all extra transmitters. However, ensure that
you leave 10 seconds in between the reception of the last transmitter and the set-
up of the following transmitter. The Weather clock will number the transmitters in
46