Advertisement
12) To confirm a flush alignment into the decorative enclosure, temporarily snap the filter/control section into the liner
shell. Adjust corner screws if necessary.
13) Unsnap the filter/control section from the bottom of the liner shell and insert wood screws (included) in the remaining
holes along the bottom edge of the liner shell.
14) Raise the blower plate into the liner shell first aligning the ducting (M600 blower only) and then aligning the blower
mounting studs to the holes in the blower plate. Secure the blower assembly with the nuts provided. This duct connection
typically cannot be sealed.
15) Hold the filter/control section just below the liner shell and connect the motor harness and power cord to the sockets
in the filter/control section electrical cover. Snap the filter/control section to the bottom of the liner shell. Secure the left
and right filter/control section safety straps to the studs on the inside ends of the liner shell with the nuts previously
removed in Step 5.
16) To install the baffle filter, hold the filter with the knob facing down and toward the front of the hood. Insert the back of
the filter into the back filter channel with enough force to compress the filter spring. Raise the front of the filter inline
with the front filter channel and slowly release the spring force.
To remove the baffle filter, push the filter knob toward the back filter channel to compress the filter spring. Lower the
front of the filter below the front filter channel and slowly release the spring force.
17) Refer to the Owner Maintenance Guide Operating Instructions for proper hood operation. Test all blower and light
functions to ensure they are operating properly.
L154 0311A
Installation Details Continued
Page 5
Advertisement
