Panasonic AG-BS300E Operating Instructions Manual page 21

List of Menus
(continued)
<DOWNCON SETTING> Only displayed when in HD mode
Item / Data Saved
DOWNCON SQUEEZE
MODE
SIDE-CROP
LETTER BOX
DETAIL ON
OFF
DETAIL LEVEL 0
:
8
:
31
DETAIL CORING 0
:
1
:
15
2D LPF ON
OFF
<SETUP>
Item / Data Saved
SETUP 0%
7.5%
<Note>
The ____ in the Variable Range column indicates the preset mode.
Variable Range
Set the mode for the composite signal output from the VIDEO OUT (MENU)
connector.
SQUEEZE:
SIDE-CROP: Video will be cropped on both sides.
LETTER BOX:Video will be squeezed vertically.
Set the ON/OFF of the detail function of the composite signal output from the VIDEO
OUT (MENU) connector.
ON:
OFF:
Detail component that was set during the HD signal processing of the camera
recorder is included in the composite signal output from the VIDEO OUT (MENU)
connector.
This setting will superimpose the detail signal of the composite signal output from the
VIDEO OUT (MENU) connector on the signal from the camera recorder.
Detail signal that was added during the HD signal processing cannot be turned OFF
even if this setting is turned OFF.
Set the level of the detail component for the composite signal output from the VIDEO
OUT (MENU) connector.
<Note>
Detail signal is added to the menu, status, and TC display of the camera recorder
when the detail level is increased.
Set the level of the noise elimination level included in the detail component for the
composite signal output from the VIDEO OUT (MENU) connector.
Perform the setting of the 2D low-pass filter which will reduce the cross-color.
ON:
OFF:
<Note>
2D LPF effect will be minor when the system mode of the camera recorder is 1080-
50i, 720-50P, or 576-50i.
Variable Range
Perform the setting of the setup level against the composite signal output from the
VIDEO OUT (MENU) connector. (Only for 59.94i)
0%:
7.5%:
Setup level will become 0 % when the system frequency is 50 Hz. When the system
frequency is 59.94 Hz, set the setting value in this menu to match the SETUP menu of
the camera recorder and the SETUP level of the video signal input to the RET IN
VIDEO connector.
Video will be squeezed horizontally.
Detail signal will be added.
Detail signal will not be added.
Reduction of cross-color is performed.
Reduction of cross-color is not performed.
Setup level is 0 %.
Setup level is 7.5 %.
Note
Note
21