(3) Setting to cut crown moldings at positions
Turn the turn table to the right and set the miter angle as follows:
1
For 45û type crown moldings: 35.3û ( mark)
For 38û type crown moldings: 31.6û ( mark)
Tilt the head to the right and set the bevel angle as follows:
2
For 45û type crown moldings: 30û ( mark)
For 38û type crown moldings: 33.9û ( mark)
Position the crown molding so that the upper surface (
3
Fig. 46 .
(4) Setting to cut crown moldings at positions
1
Turn the turn table to the left and set the miter angle as follows:
For 45û type crown moldings: 35.3û ( mark)
For 38û type crown moldings: 31.6û ( mark)
Tilt the head to the right and set the bevel angle as follows:
2
For 45û type crown moldings: 30û ( mark)
For 38û type crown moldings: 33.9û ( mark)
Position the crown molding so that the lower surface (
3
Fig. 47.
Fig. 40
Fig. 42
and
1
and
2
--- 31 ---
in Fig. 39 (See Fig. 44, tilt the head to the right.):
4
in Fig. 38) contacts the fence as indicated in
B
in Fig. 39 (See Fig. 45, tilt the head to the right.):
3
in Fig. 38) contacts the fence as indicated in
A
Fig. 41
Fig. 43