Wps Setup - Planet VDR-300NU User Manual



WPS Setup

There are 2 primary methods used in the Wi-Fi Protected Setup:
 PIN entry, a mandatory method of setup for all WPS certified devices.
Enter STA PIN: If you select it, you need to enter the station PIN from client.
Use AP PIN: The PIN is generated by AP.
 Push button configuration (PBC), an actual push button on the hardware or through a simulated push
button in the software. (This is an optional method on wireless client).
If you are using the PIN method, you will need a Registrar (access point/wireless router) to initiate the
registration between a new device and an active access point/wireless router.
The PBC method may also need a Registrar when used in a special case where
the PIN is all zeros
In order to use the push-button for WPS authentication, you must ensure that the network card supports
the function. If it supports, you need not to do any configuration. You can press the WPS button directly to
enable the WPS function.
 Manual Setup AP
This page provides 9 types of network authentication modes, including Open, Shared, 802.1X, WPA,
WPA-PSK, WPA2, WPA2-PSK, Mixed WPA2/WPA, and Mixed WPA2/WPA-PSK.
Figure 5-3-4
100
User Manual of VDR-300NU