Table of Contents
Advertisement
Move the cursor to INITIAL INFORMATION and then click confirm button, you can see the above
interface.
Here you can view dome basic information.
4.4.1.2 Address Information
Move the cursor to SITE INFORMATION and then click confirm button.
ADDR TYPE: There are two options: soft and hard. Please use the left/right button on the
keyboard or in the speed dome terminal menu to set.
ADDR-HARD: It is an address you set in the dial switch. You can not modify it through
software.
ADDR-SOFT: You can set address via software. It is to say, you can use menu to modify
dome address. The value ranges from 1 to 255.
BACK: Go back to the previous menu.
EXIT: Log out system menu.
4.4.1.3 System Time Setting
Move the cursor to SYSTEM TIME SETING and then click confirm button, you can go to the
third submenu. Please use the left/right button on the keyboard or in the speed dome
terminal menu to set. After completed setup, please click confirm button to save current
setup. After you see speed dome menu displays OK, you can see the setup is valid now.
4.4.2
Display Setting
ADDR
： 001-H
BAUD RATE ：9600
PARITY
：NONE
PROTOCOL ：PELCO-D
MODEL
：SD6663-HN
TEMP
: 032℃
SOFTWARE ：v1.04.3
BACK
EXIT
ADDR TYPE
ADDR-HARD
ADDR-SOFT
BACK
EXIT
YEAR
: 2009
MONTH
: 001
DATE
: 017
WEEK
: SUNDAY
HOUR
: 013
MINU：
: 052
SAVE
BACK
EXIT
PRESET TITLE
：ON
AZIMUTH DISP
：ON
TIME DISP
：OFF
POSITION
：OFF
ZOOM DISP
：OFF
INSIDE TEMP
：℃
OUTSIDE T&H
：OFF
IDLE TIME
:1 Min
TITLE DISP
：OFF
BACK
EXIT
: HARD
: 001
: 001
22
Advertisement
Table of Contents
