Table of Contents
Advertisement
Quick Links
INSTALLATION & USER INSTRUCTIONS
Superior Fires
Christchurch, Dorset BH23 2BT
Tel: 08002 300212
Fax: 01202 499326
www.superiorfires.co.uk
e : info@superiorfires.co.uk
PLEASE NOTE: LCD ELECTRIC FIRE MAY BE SUPPLIED WITH DIFFERENT FRET & FRAME THAN
Please note : Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Focal Point Fires plc. You are not per-
mitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.
LCD ELECTRIC FIRE
MODELS COVERED BY THESE INSTRUCTIONS
LCD INSET ELECTRIC FIRE
FRET AND FRAME OPTIONS AVAILABLE
MODEL SHOWN : BLENHEIM LCD INSET ELECTRIC FIRE
SHOWN
All instructions must be handed to the user
Revision A - 01/13
1
GB IE
for safekeeping.
2013 Focal Point Fires plc.
Advertisement
Table of Contents
Related Manuals for superior fires LCD ELECTRIC FIRE
Summary of Contents for superior fires LCD ELECTRIC FIRE
- Page 1 : info@superiorfires.co.uk MODEL SHOWN : BLENHEIM LCD INSET ELECTRIC FIRE PLEASE NOTE: LCD ELECTRIC FIRE MAY BE SUPPLIED WITH DIFFERENT FRET & FRAME THAN SHOWN All instructions must be handed to the user Please note : Except where otherwise stated, all rights, including copyright in the text, images and layout of this for safekeeping.
-
Page 2: Appliance Data
I N S TA L L AT I O N & U S E R I N S T R U C T I O N S GB IE Section Contents Page No. Section Contents Page No. Preliminary Notes Safety Cut-Out System Appliance Data Installating The Appliance Installation Requirements... -
Page 3: Unpacking The Appliance
3.0 INSTALLATION REQUIREMENTS - GB IE CONTINUED This appliance should be positioned on a firm level surface and in a clean ‘dust free’ environment. If the fire is to be sited in a fire surround then the suitability of the surround for use with electrical heaters should be established with the fire surround manufacturer. If fitted into an open draught fireplace, it is advisable to blank off the chimney to reduce the risk of draught through the fire, which may cause the safety cut out system in the fan heater to operate. - Page 4 6.0 OPERATING THE APPLIANCE GB IE - CONTINUED Fig. 1 - Log fire Fig. 2 - Twig fire Fig. 3 - Coal fire Controlling the LCD display panel LCD on/off control: The LCD display may be switched on and off indepenently of the heater Fig.
-
Page 5: Installing The Appliance
8.0 INSTALLING THE APPLIANCE GB IE CAUTION: DO NOT CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY AT Neoprene Strip THIS TIME To ensure the appliance is positively located into position, it is necessary to secure it in place using the double-sided neoprene strips included in the instruction pack. Peel off the adhesive backing from one side of each strip and apply to the periphery of the REAR of the appliance frame, as shown in figure 11.
Need help?
Do you have a question about the LCD ELECTRIC FIRE and is the answer not in the manual?
Questions and answers