Memory Card - Spypoint HD-7 User Manual

6
POWER
The battery level is shown on the LCD screen. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Also note that the voltage of rechargeable AA batteries
(1.2V) is insufficient to power this SPYPOINT
During the installation of the AA batteries, slide the switch
inside the battery case to ALK. Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera can be powered by a rechargeable lithium battery
pack LIT-09/LIT-C-8 (sold separately, see OPTIONS). This
type of battery is less affected by cold temperatures and lasts
up to 3 times longer then an alkaline batteries. During the
installation of the lithium battery pack, slide the switch inside
the battery case to LIT-09.
External (12V)
This camera can also be powered from an external 12-volt
DC input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately).
During the installation of a 12-volt connection, place the switch
inside the battery case to
safely inside the camera). If combined with a lithium battery
pack, slide the switch to LIT-09.
refer to the section OPTIONS.
®
camera.
ALK (the AA batteries can remain
For the accessories available,
Solar panel
This camera also offers the possibility of a connection to a solar
panel SP-12V (sold separately, see OPTIONS) to maintain the
charge of the lithium battery pack (sold separately). During the
installation of the rechargeable lithium battery pack, slide the
switch inside the battery case to LIT-09 to activate the charging
system of the solar panel.
Power source
• 6AA
• 12V
• 12V + 6AA
• LIT-09
• 12V + LIT-09
• Solar panel + LIT-09

MEMORY CARD

Using a memory card is required to operate this camera. When
the camera is ON and no memory card is used, the LCD screen
displays "CArd" meaning to insert one. The camera can accept
memory cards up to 32 GB capacity. Before inserting or
removing the memory card, the camera must be turned OFF.
Failing to do so may cause damage or loss of the pictures
already recorded on the memory card. When the SD card is full,
the LCD screen indicates "FUL". The following data shows an
approximate quantity of photos which can be recorded by the
camera depending on the memory card capacity.
RESOLUTION 2.0 GB
3 MP 2000
7 MP 1400
VIDEO RESOLUTION
320 x 240 2h
640 x 480 65 min
Switch Position
ALK
LIT-09
4.0 GB 8.0 GB 32 GB
4100 8200 32800
2700 5500 21800
4h 8h 32h
2h10 4h10 16h40
7