Ibm-3415 Parts Checklist - IBM -3415 Installation And Operating Manual

IN USE
VOLUME
1 2 ABC 3 DEF
4 GHI 5 JKL 6 MNO
PQRS TUV WXYZ
7 8 9
OPER
TONE 0 #
REDIAL FLASH
1. Handset
4. DC power adapter
7. 7-foot line cord
for desk use
8. Short line cord
for wall installation

IBM-3415 PARTS CHECKLIST

CHARGE/
IN USE
5. Belt-Clip
9. 10-number
memory sticker
2. Base
5
3. Reversible pedestal
6. Ni-Cd Battery Pack
QUICK START GUIDE
IBM-3415
IBM-3150
®
SETTING UP THE BASE CONNECTING THE PHONE TO THE WALL JACK
BASE
1. Insert the pedestal into the slots on the bottom 1. Connect the telephone line cord to the
B A S E
"Line1 / 2" and "Line2" jacks and to the
of the base and slide up to lock in place. The
telephone outlets.
pedestal is reversible for desk or wall mounting.
2. Use the "Line1 /2" jack if you are con-
2. Connect the telephone line cord to the
P E D E S TA L
necting only one phone line.
LINE 1/2 LINE 2 9V DC "TEL LINE" jack and to a telephone outlet.
3. Connect the AC power adapter to
Power Source 300mA Use only with class 2 P E D E S TA L
P/T DC-9V TEL LINE
3. Connect the AC power adapter to the 9V DC
the (9V DC) jack and to an AC outlet.
jack and to an AC outlet.
The POWER lamp on the base will
glow green.
4. Raise the antenna vertically.
4. Raise the antenna vertically.
INSTALL THE BATTERY
1. Slide open the battery door.
1. Slide open the battery door.
2. Plug the battery terminal together.
2. Plug the battery terminal together.
3. Insert the battery into the battery
3. Insert the battery into the battery compartment.
compartment.
4. Place the handset on the base and allow to
4. Place the handset on the base and allow
charge for 12 hours.
to charge for 12 hours.
MAKING CALLS
1. Pick up the handset from the base.
1. Pick up the handset from the base.
2. Press B or C.
2. Press P . The LED on the base will flash while the handset is scanning
for a clear channel. The LED will glow steadily when the connection is
3. Dial the number you wish to dial.
made. Wait until you hear a dial tone.
4. When you are finished talking, press the B or C keys depending on
3. Dial the number you wish to dial.
which line is active or place the handset back into the base to end the call
4. When you are finished talking, press the P key or place the unit back
into the base to end the call.
Note: The "CHARGE/IN USE" light on the base will turn green when
the line is active.
10. Quick Start Guide