Tone/Pulse Switch
1. Choose the correct dialing mode
2. Select either Tone or Pulse dialing mode by setting the switch at the back of the base unit.
Note: Changes to the switch position during a call do not take effect until the call has ended.
Tip:
If you are unsure of the proper dialing mode, make a trial call with the dial mode
setting to TONE. If the call goes through, leave the switch in (TONE mode), otherwise,
set to PULSE.
Ringer Setting
1. To turn the ring ON or OFF, set the RINGER
switch located on the handset to the desired
position.
TELEPHONE SETUP
Use only with class 2
Power Source 300mA
13
P/T