Electrical Adjustment - Sanyo VPC-E6 Service Manual

3. ELECTRICAL ADJUSTMENT

3-1. Table for Servicing Tools
Ref. No. Name
J-1 Pattern box (color viewer)
J-2 Calibration software
J-3 Chroma meter
J-4
Spare lump
J-5 Discharge jig
J-6 Collimator
Note: J-1 Pattern box (color viewer) is 100 - 110 VAC only.
J-1
J-3
J-5
3-2. Equipment
1. Oscilloscope
2. Digital voltmeter
3. AC adaptor
4. PC (IBM R -compatible PC, Pentium processor, Window
98 or Me or 2000 or XP)
3-3. Adjustment Items and Order
1. IC501 Oscillation Frequency Adjustment
2. Lens Adjustment
3. AWB Adjustment
4. CCD White Point Defect Detect Adjustment
5. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Note: Item 2-5 adjustments should be carried out in sequence.
Part code
Number
VJ8-0190
1
VJ8-0263
1
1
VJ8-0192
1 VJ8-0191
1 VJ8-0188
1 VJ8-0260
J-2
J-4
3-4. Setup
1. System requirements
Windows 98 or Me or 2000 or XP
IBM R -compatible PC with pentium processor
CD-ROM drive
3.5-inch high-density diskette drive
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Installing calibration software
1. Insert the calibration software installation diskette into your
diskette drive.
2. Open the explorer.
3. Copy the DscCalDI_150 folder on the floppy disk in the FD
drive to a folder on the hard disk.
3. Installing USB driver
Install the USB driver with camera or connection kit for PC.
4. Pattern box (color viewer)
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
the lump and its circumference are high temperature during
use and after power off for a while.
5. Computer screen during adjustment
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
PAF Cal.
OK
EVF
Cal Data
LCD Type
OK
USB storage
VID
Get
PID
Set
Backrush pulse :
Get
3-5. Connecting the camera to the computer
1. Line up the arrow on the cable connector with the notch on
the camera's USB port. Insert the connector.
2. Locate a USB port on your computer.
3. Insert the AC adaptor's cable to DC jack.
4. If "USB CONNECTION" is displayed, choose the "CARD
READER", and press the SET button.
– 15 –
2 . Be careful of handling
LCD
RGB Odd RGB Even
RGB Gain VCOMDC
Tint Phase
VCO
H AFC Test
Set Serial Set
Set Rev. Set
Factory Code
Set
VCOMPP(LOW)
VCOMPP(HI)
Setting
Language
Video Mode