3-3. Adjustment Items and Order
1. IC501 Oscillation Frequency Adjustment
2. IRIS Adjustment
3. Lens Adjustment
4. AWB Adjustment
5. CCD White Point Defect Detect Adjustment
6. CCD Black Point Defect Detect Adjustment In Lighted
7. LCD Panel Adjustment
7-1. LCD RGB Offset Adjustment
7-2. LCD Gain Adjustment
Note: If the lens, CCD and each board, it is necessary to
adjust again.
3-4. Setup
1. System requirements
Windows 98 or Me or 2000 or XP
IBM R -compatible PC with pentium processor
CD-ROM drive
3.5-inch high-density diskette drive
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Installing calibration software
1. Insert the calibration software installation diskette into your
diskette drive.
2. Open the explorer.
3. Copy the DscCalDI_140 folder on the floppy disk in the FD
drive to a folder on the hard disk.
3. Installing USB driver
Install the USB driver with camera or connection kit for PC.
4. Pattern box (color viewer)
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
2
. Be careful of handling
the lump and its circumference are high temperature during
use and after power off for a while.
5. Computer screen during adjustment
LCD
Calibration
Upload
RGB Odd
RGB Even
VCOMPP(LOW)
AWB
Firmware
Focus
RGB Gain
VCOMDC
VCOMPP(HI)
Image
UV Matrix
Tint
Phase
Cal Mode
Initialize
Hall Cal.
OK
VCO
EVF
H AFC
Test
Cal Data
LCD Type
OK
Setting
Language
USB storage
VID
Get
Set
Serial
Set
Video Mode
PID
Set
Rev.
Set
Set
Factory Code
Page 14