Setup - Recording Mode - Nadatel SDVR-4300 User Manual

3-3. Setup – Recording Mode
Menu item
RESOLUTION
CHANNEL
FRAME RATE
QUALITY
RECORDING
MOTION ZONE
MOTION
SENSITIVITY
SENSOR TYPE
PRE RECORD
POST EVENT
RECORD
ALARM
ALARM DURATION
SCHEDULE
Table 3.3.1. Menu items in Recording mode setup
Set resolution to either
704x480(NTSC)/704X576(PAL) or 352x240(NTSC)/352X288(PAL).
Select the channel for applying the following settings.
Set the frame rate for the specified channel. The sum of the frame rate values
from each channel cannot exceed maximum frame rates for a particular
recording resolution. Typical values of the maximum frame rate for NTSC
video are 120/100fps for 352x240(NTSC)/352X288(PAL) and 30/25 fps for
704x480(NTSC)/704X576(PAL)
Select the recording quality for the specified channel from normal, high, and
superior.
Assign the recording mode for each channel. Recording modes: Continuous,
Motion, Sensor, Schedule, and Disable.
Select Full Zone or Partial Zone for motion sensing. If the Partial Zone is
selected, screen will be change as shown in figure 3.3.2.
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
Set the type of sensor for the specified channel from none,
N/O (normal open), and N/C (normal closed).
Enable/disable pre-event recording. Pre-event recording time is 5 sec and only
intra-frames are recorded for pre-event recording.
Set post event recording time duration for the specified channel
Enable/disable alarm generation for the specified channel.
Set alarm time duration for the specified channel.
Set recording schedule. If this menu item is selected, screen will change as
shown in figure 3.3.3.
Description
16