Table of Contents
Advertisement
5. Locate the battery (connector BAT1) on the system board.
Microprocessor 1
(U1)
6. Remove the battery:
a. Use one finger to press on the tab that secures the battery to its housing.
b. Use one finger to slide the battery up and out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
7. Insert the new battery:
a. Hold the battery so that the larger side is facing up.
b. Place the battery into its socket, and press the battery down until it snaps
into place.
8. Put the PCI adapter shield back into place.
9. Reinstall the server cover, and connect the cables.
PCI-X slot 1 (PCIX1)
PCI-X slot 2 (PCIX2)
Battery (BAT1)
Remote Supervisor
Adapter II (JMGT1)
Microprocessor 2 (U2)
Chapter 2. Installing options
29
Advertisement
Table of Contents
