Table of Contents
Advertisement
v If you plan to use a RAID adapter to control internal hot-swap hard disk drives,
14
326 Type 8848: Option Installation Guide
disconnect the SCSI cable from the SCSI backplane signal connector (SCSI1) on
the system board and connect it to the RAID adapter. The following illustration
shows the cable routing if you are installing the RAID adapter in PCI-X slot 1.
See the documentation that comes with the RAID adapter for any additional
cabling instructions. That documentation also provides information about
installing the RAID software and configuring the RAID adapter.
RAID adapter
SCSI cable
SCSI backplane
signal connector
(J8)
to hard disk drives
Advertisement
Table of Contents
