Table of Contents
Advertisement
v If you plan to install an optional IBM Remote Supervisor Adapter II, install it in
PCI-X slot 2. Use the ribbon cable that comes with the Remote Supervisor
Adapter II to connect the 20-pin connector on the rear edge of the adapter to the
Remote Supervisor Adapter II connector (JMGT1) on the system board. For
details about installing a Remote Supervisor Adapter II, see the documentation
that comes with the adapter. The following illustration shows the cable routing.
Remote Supervisor
Adapter II
Cable
Remote Supervisor
Adapter II connector
(JMGT1)
Chapter 2. Installing options
15
Advertisement
Table of Contents
