OzCharge OC-SW121040 User Manual

Automatic battery charger, switching mode with micro-controlled input:220-260vac / output: 12volt dc

Advertisement

User's Manual and Important Safety Information

FEATURES

Congratulations on purchasing an OzCharge Automatic / Switching Mode Battery Charger.
OzCharge Battery Chargers comprise of the latest technology and they incorporate the following features:
High frequency Switching Mode
Full time pulse charge output
Microprocessor controlled
Multi charging rate - Selectable
Suits Lead Acid Battery Types: Calcium, Conventional, Sealed, WET, GEL - Selectable
Battery rejuvenation (De-Sulphation) function - Selectable
Heavy-duty cables
Corrosion-resistant output connectors and clamps
Designed for Australian Conditions.
- - - - - - - - - - - - - - - - - - - WARNING - - - - - - - - - - - - - - - - - - - - -
This charger is designed for indoor use only and should never be exposed to rain.
Make sure you are using proper AC line power voltage.
Do not attempt to use the charger if it has been dropped or damaged.
Never attempt to charge a damaged battery, frozen battery or non-rechargeable battery.
Do not use the charger in a closed area or poorly-ventilated area.
Never smoke, use an open flame, or create sparks near a battery or charger during charging operation as
this may cause an explosion / explosive gas.
Do not operate the charger if the cord or plug is damaged.
Do not disassemble the charger. Take it to a qualified person if a repair is required.
Keep the charger away from infants, children and pets.
Switch off the mains power supply before connecting or disconnecting the unit to a Battery.
CAUTIONS
Refer to the battery Manufacture's specific recommended values to determine your Battery Type and for
setting the charging rate.
Check the Battery Manufacture's specific precautions - such as removing or not removing cell caps whilst
charging.
Please ensure the correct Battery Type is selected. Do not charge using an incorrect Battery Type Setting.
(For example, do not charge a Gel battery with Calcium battery selection setting as this may damage your
battery)
Someone should be within range of your voice or close enough to come to your aid if working near a
lead-acid battery.
Wear protective goggles and turn your face away when connecting or disconnecting a battery.
If battery acid contacts your skin or clothing, wash immediately with soap and water. If acid enters your eye,
immediately flush the eye with running cold water for at least 10 minutes and seek medical attention
immediately.
To reduce risk of damaging the Battery, avoid dropping any metal tools onto the battery.
Never rest the Battery being charged on top of your OzCharge Battery Charger.
The Battery Charger should be kept as far away from the Battery as the output cables permit.
Automatic Battery Charger
Switching mode with Micro-controlled
Input:220-260Vac / Output: 12Volt DC
Model: OC-SW121040 / OC-SW121060
-
1-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OC-SW121040 and is the answer not in the manual?

Questions and answers

Summary of Contents for OzCharge OC-SW121040

  • Page 1 User’s Manual and Important Safety Information Model: OC-SW121040 / OC-SW121060 FEATURES Congratulations on purchasing an OzCharge Automatic / Switching Mode Battery Charger. OzCharge Battery Chargers comprise of the latest technology and they incorporate the following features: • High frequency Switching Mode •...
  • Page 2 Press to Select the Current Charge Rate. 2. Charging Current LED Display LED indicates the selected charging current (1A or 2A or 4A) (Model: OC-SW121040) LED indicates the selected charging current (2A or 4A or 6A) (Model: OC-SW121060) 3. Battery Type Selection Button Press to select the Battery Type.
  • Page 3: Operating Instructions

    OPERATING INSTRUCTIONS The OzCharge Battery Charger is easy to operate and very simple to use. Please refer to the operating instructions below. 1. Pre-Charge Check (a) Check the Battery Electrolyte level (Non-sealed Batteries). - If necessary, remove the vent caps and add distilled water so the levels are halfway between the upper and lower fill lines.
  • Page 4 (Indicated by the Full LED ON) Rejuvenation Process (EXTEND YOUR BATTERY LIFE) Your OzCharge Battery Charger provides a battery rejuvenation function. What does this feature do?? - Rejuvenation has been proven to break down the crystalline form of lead sulphate within the battery cells which helps extend your battery life.
  • Page 5: Charging Stages

    5. Charging output voltage (Automatic Equalisation): 16.2V only for Calcium battery 6. Float output voltage: 13.8V at Gel/Sealed, WET/Calcium 7. Operating Environmental: 0~40 degC, 90% RH maximum; non-Condensing 8. Net Weight: 630g approx (OC-SW121040 & OC-SW121060) 9. Dimension: L164 x W85 x H65mm (OC-SW121040 & OC-SW121060)
  • Page 6: Trouble Shooting

    Website: If the Authorised Supplier and / or OzCharge service centre concludes that while under normal use, a product failure or malfunction occurred during the warranty period and was caused by a defect in material or workmanship (see Exclusions), the Customer will be asked to ship to the nearest service point.
  • Page 8 Distributed by Zylux Distribution Pty. Ltd. www.ozcharge.com.au Rev. 1.06...

This manual is also suitable for:

Oc-sw121060

Table of Contents