Connecting The Gas; Leak Testing - Igloo IGW 400 Assembly And Operating Instructions Manual

MAIN BURNER AND SIDE BURNER WITH RESPECT TO PROPER
LOCATION: WARNING – ALWAYS CHECK TO ENSURE BURNERS ARE
POSITIONED CORRECTLY BEFORE EACH USE
Valve
Main valve orifice with burner properly positioned
[Internal connection]

CONNECTING THE GAS

Connecting to a Gas Cylinder
1. Ensure all control knobs are in the OFF position and verify that the LP gas cylinder valve is closed by turning the
handle on the LP gas cylinder valve clockwise until it stops.
2. Remove the protective cap from the LP cylinder valve nozzle.
3. Hold regulator in a straight line with LP cylinder valve nozzle so the connection does not cross thread.
4. Insert regulator nipple into the LP cylinder valve nozzle opening.
5. Hand-tighten coupling nut in a clockwise direction. Do not use tools!
6. Perform a Leak Test.(See Leak Testing section of this manual).
Disconnecting the Gas Cylinder
1. Turn all control knobs to the OFF position and turn
the handle on the LP gas cylinder clock-wise until it stops.
2. Turn coupling nut on regulator in a counter-clockwise direction
until regulator is released from threaded LP cylinder valve nozzle.
3. Place the protective cap over LP cylinder gas nozzle.

LEAK TESTING

Always perform a leak test in a well-ventilated area.
Step 1- Confirm all control knobs are in the off position.
Step 2- Turn on the gas at the gas cylinder.
Step 3- Check for leaks by brushing a solution of
Burner
1
/ water and
2
18
Valve
Side valve orifice with burner properly positioned
[Internal connection]
1
/ liquid detergent over all the gas system joints,
2
Burner pipe