Table of Contents
Advertisement
C
S
ONFIRM
ENSOR
It is important to confirm that the Sensor is installed and operating
correctly by reviewing the GPS and heading data on the control head.
NOTE: The Sensor may experience a cold start upon first
power up. It may take several minutes for the Sensor to
locate satellites and lock a GPS position.
4
|
Select the GPS Source
If Auto-Configure is turned on, the control head may not
automatically select the Sensor as the primary GPS source. Use the
following instructions to select the Sensor as the primary GPS source:
1. Press the POWER key to power on the control head.
2. From the Home screen, select the GPS tool
3. Under GPS Source, select GPS (1).
4. Turn OFF Auto-Configure.
5. Select External GPS CI.
NOTE: See the section
information.
NOTE: See your control head operations manual for more
information about the menu system.
NOTE: To assign a secondary GPS Source, select GPS (2).
O
PERATION
14
GPS Status Tool
.
for more
Confirm Operation
Advertisement
Table of Contents
