Table of Contents
Advertisement
A
|
Stem Mount with 1"-14 Thread
Use the following instructions to stem mount the Sensor:
WARNING! Do NOT mount the Sensor to a stem mount or
antenna pole that contains ferrous metals.
NOTE: It is important to review the mounting
considerations and test run the cable route as indicated
in Section 1 before proceeding with the installation.
1a. If you have a pre-existing stem
mount, skip to step 2.
1b. If you need to mount the antenna
pole (stem), mark the chosen
mounting location and drill a 3/4"
(19 mm) diameter hole for the cable
and cable connector.
1c. If you have purchased hardware to
stem mount your Sensor, follow the
instructions
hardware to attach the stem to the
boat.
2. Screw the Sensor base onto the stem
first, making sure that the stem pipe
does not protrude from the Sensor
base. (This adds protection to the
cable when it is pulled through the
pipe stem.) Deburr the pipe edges to
reduce cable abrasion.
Installation - Stem Mount
included
with
7
Stem Mount:
Attaching the Sensor
Base to the Stem
that
cover
base
stem
Advertisement
Table of Contents
