Table of Contents
Advertisement
4. Move the Sensor to the side and drill the two 5/32" (4 mm) pilot
holes.
NOTE: Apply marine-grade silicone caulk or sealant to
both screw and drilled holes as needed to protect your
boat from water damage.
5. Align the Sensor's screw holes over the
pilot screw holes and attach with the
#8 - 1 1/4" (32 mm) screws. Hand
tighten only.
Attaching the Sensor to
the Mounting Surface
12
Installation - NO Access Under
#8 - 1 1/4"
mounting screws
cable routed to the side
Advertisement
Table of Contents
