Table of Contents
Advertisement
B
|
Deck Mount with Access Under Mounting Location
Use the following instructions to deck mount the Sensor and route
the cable down through the mounting surface:
NOTE: It is important to review the mounting
considerations and test run the cable route as indicated
in Section 1 before proceeding with the installation.
1. Mark the mounting location and drill a 3/4" (19 mm) diameter
hole for the cable and cable connector.
2. Route the Sensor cable through the planned cable route. To use
extension cables, see the details in Section 1, Determine the
Mounting Location.
3. Cover the cable hole with the Sensor.
4. Position the Sensor so the arrow on the cover is pointed
straight toward the front of the boat in the direction of travel.
The arrow should be parallel with the keel. See the illustration
Positioning the Arrow on the Compass.
NOTE: Failure to align the Sensor correctly will result in
incorrect compass readings.
5. Make sure the Sensor is flush against the surface, and mark the
two mounting holes with a pencil or awl.
6. Move the Sensor to the side and drill two pilot holes, using a
5/32" (4 mm) bit.
NOTE: Apply marine-grade silicone caulk or sealant to
both screw and drilled holes as needed to protect your
boat from water damage.
Installation - Access Under
9
Advertisement
Table of Contents
