Visual Circuits Firefly User Manual page 32

Quick Start Guide
For Composite monitors: Connect a BNC-ended
composite cable (not included) to the corresponding
Channel 1 composite connector on the back of the Firefly.
Connect additional video cables for Channels 2, 3 and 4 (if
desired).
For S-Video monitors: Connect a BNC-ended Y s-video
cable (not included) to the corresponding Channel 1 chroma
(C) and luma (Y) connectors on the back of the Firefly.
Connect additional video cables for Channels 2, 3 and 4 (if
desired).
For Component monitors: Connect BNC-ended
component cables (not included) to the corresponding Pr, Y
and Pb connectors on the back of the Firefly. Connect
additional video cables for Channels 2, 3 and 4 (if desired).
For RGB monitors: Connect a a BNC-ended RGB cable
(not included) to the corresponding red (R), green (G) and
blue (B) connectors on the back of the Firefly. Connect
additional video cables for Channels 2, 3 and 4 (if desired).
NOTE
You can configure the Firefly video output type on an
independent, channel-by-channel basis. (Example:
CH1 & 2: Composite monitors; CH: 3: Component
monitor; CH4: RGB monitor). Configuring the video
output type(s) is found in Firefly System Settings: Video
menu, which is accessible using the remote control,
front panel or WebView.
See Channel 1, 2, 3, 4 Video Output on page 77 in the
main body of the user manual for information on
selecting the video output type(s) using the remote
control.
4