Parts Replacement - STAR TRAC FITNESS Spinner Blade User Manual

PARTS REPLACEMENT

B P R
RAKE AD EPLACEMENT
Removal
1. Remove tension from the brake pad by turning the Brake System
Resistance knob counterclockwise, until completely loose.
2. Using a 10mm Socket Wrench, remove the two bolts supporting the
brake pad onto the frame.
Installation
1. Carefully re-install the two bolts through the brake pad bracket onto the
frame. Tighten by using a 10mm Socket Wrench.
C R
HAIN EPLACEMENT
CAUTION! : DO NOT GET YOUR FINGERS CAUGHT IN THE CHAIN OR SPROCKETS FOR IT MAY
CAUSE SEVERE INJURY!
Note: Install only Star Trac approved replacement chain. Only a certified Star Trac® technician should
perform the following:
1. Remove the chain guard by unscrewing the chain guards screws.
2. Apply tension to the brake knob by turning it all the way clockwise so the flywheel does not turn.
3. Using the 19mm socket and socket wrench, loosen the axle nuts on both sides of the flywheel.
4. Using the 10mm open end wrench, loosen the lock nuts on the chain adjustment screws.
5. Loosen the adjustment screw to allow the slack in the chain.
6. Using a chain break tool, cut the chain open and remove the chain from the bike.
7. Put the new chain on the front sprocket and over the crank arm.
8. Lift chain up onto the rear large sprocket and slowly turn the crank arm until the chain wraps around the sprocket.
9. Proceed to "Chain Adjustment" section (Page 18) for proper adjusting the chain tension properly.
3DJH  63,11(5 86(5·6 0$18$/
Š