Maintenance; Moving And Leveling; Preventive Maintenance - STAR TRAC FITNESS Spinner Blade User Manual

0
$,17(1$1&(
This section provides the procedures to maintain the Spinner
where applicable.

MOVING AND LEVELING

To move the bike to a new location:
Lift the bike from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the bike from one location to another.
To level the bike:
Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven floor surfaces.

PREVENTIVE MAINTENANCE

Perform regular scheduled preventive maintenance procedures to maintain your Spinner
Note: Star Trac strongly recommends replacing the pedals after two years of use.
NCE
AINTENA
T
OOLS
Tools required for service and maintenance of your Spinner
Tool
Pedal Wrench, 15mm*
Shimano-compatible Bottom Bracket Tool*
Cotterless Crank Puller*
Metric Allen Wrench Set and Metric Socket, 2mm ~ 6mm
Crescent (adjustable) Wrench
Torque Wrench
* Available at local bike or fitness-related stores.
D M
AILY AINTENANCE
The service life of your Spinner
Spinner indoor cycling bike after each use to remove sweat and moisture. It is best to use a liquid non-abrasive cleaner and water solution.
®
Wipe Down / Cleaning
To prevent the build-up of rust and other forms of corrosion, wipe down the bike at the end of each day (or preferably at the end of each class). Raise
all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration can settle. Give particular attention to
the following areas:
Handlebar
o
Seat / adjustable slide for the seat
o
Flywheel
o
Back leg assembly
o
Chain guard
o
Brake knob and bolt assembly
o
Pop-pins
o
Leveling feet
o
NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the bike.
NOTE: Release all tension from the resistance knob after each use to allow for perspiration to evaporate. If bikes are used in a class setting, the
instructor may direct class participants to release all tension for the resistance knob after each use.
3DJH 
®
indoor cycling bike are listed below.
®
indoor cycling bike will be determined by how consistently you perform the daily maintenance procedures. Dry the
®
indoor cycling bikes in serviceable condition. Differences between models are noted
indoor cycling bike in serviceable condition.
®
Purpose
Remove and install pedals.
Remove, install and adjust the bottom bracket. (Spinner
Remove crank.
Install and adjust leg bolts, chain tensioner, brake pad and crank bolts.
Adjust chain tension.
Adjust crank arm.
V)
®
63,11(5 86(5·6 0$18$/
Š
B