Starting The Timed Events - Strand Lighting 301 Operation Manual

Set Fade Time
1.Fade In:00:05
2. Default (00:05)
> +/- Confirm
Repeat the above procedure for all events that have been recorded.

Starting the Timed Events

Once the timed events have been scheduled, the event list must be started for the
scheduled events to occur.
12:00:00
Event Stop
CH:01 LL:00
Start <Ms> Menu
Now that the event list has been activated, the LCD screen will
display the event that is chronologically next as well as the
time it will start. You can press the Escape key to stop it.
Note that when the event list is started, the LED indicators go out. This indicates that the faders are
no longer active. If the event list is started while a fader is active, the levels are frozen and the fader
is no longer active. Stop the event list and the output will use the default fade time to change to the
current faders levels. After that, any movement of faders will occur without using the default time.
12:00:00
Event:01 On
Off At: 17:00
Stop <Ms>
While the event is fading, the fade countdown will be displayed on
the bottom line of the LCD screen.
If the operator wishes to interrupt the event's schedule, just press Escape to stop it and the
event will fade out in the default time.
Strand 301 Console Manual
Use the Escape key to advance the cursor and set the fade time.
The default fade time is listed below.
See Set Default Fade Time to change the default.
To start the event list, just press the Escape key.
Once the event has started, the LCD displays all the information
concerning when the event will stop.
12:00:00
Event:01 Ready
On At: 08:00
Stop <Ms>
12:00:00
Event:01 On
Off At: 17:00
Stop <00:09>
Page 25